VINLASTIC – Flexible Polymer Modified Cementitious Waterproofing Coating

Description:

VINLASTIC is a two-part waterproofing system based on high-quality synthetic resin, cement, and special additives. It exhibits excellent bonding properties with various substrates.

Application Area:

Waterproofing for basements, water tanks, aqueducts, siphons, or any water-retaining structures.
Waterproofing for concrete structures such as roofs, balconies, bridges, and pitch holes.
Suitable for bathroom floors, sunken portions, kitchen sinks, and walls.

Advantages:

Excellent bonding to a variety of substrates, including concrete, plastic, and metal.
Adheres well to wet surfaces, facilitating easy and rapid application.
Very flexible, capable of withstanding moderate movements, including hairline cracks up to 0.2 mm width.
Non-toxic when used for waterproofing running water tanks.

Consumption:

Recommended consumption: 0.8 ÷ 1.2 kg/m2/coat
Number of coats recommended: 2 ÷ 3 coats

Application:

Surface Preparation:

Remove loose and deteriorated materials using high-pressure water or sand-blasting or mechanical wire brushing.
Treat, neutralize, and remove efflorescence, mold, mildew, dust, dirt, laitance, and standing water before coating application.
Fill chiseled traces with mortar (cement/sand: 1/2) using HYPERLATEX™ bonding agent.
Saturate the prepared substrate with clean water before applying VINLASTIC®.

Mixing:

Mix using a slow-speed drill (600 rpm) with a wing-type paddle for approximately 3-4 minutes until components are evenly blended to a uniform lump-free consistency.

Coating:

Apply VINLASTIC® with a brush, roller, or airless spraying machine in at least 2 coats on the substrate surface.
Apply VINLASTIC® to corners, joints, and construction joints before covering the entire surface.
Apply the first coat when the surface is still wet.
Apply the second coat at right angles to the first coat immediately after the first coat dries.
VINLASTIC® should be applied within 90 minutes from mixing.

Technical Specifications:

Property	Units	Testing Method	Specification
Product form	Part A	–	Milky liquid
	Part B	–	Grey powder
Colour	–	–	Grey
Density of mixed material	g/ml	ASTM D1475	1.80 ± 0.10
Applying temperature	oC	–	5 ÷ 45
Drying time	Hours	–	24 ÷ 48
Hardness, Shore A	–	ASTM D2240	90 ± 15
Tensile strength	MPa	ASTM D412 – 6a	≥ 0.9
Elongation at break	%	ASTM D412 – 6a	≥ 35
Adhesion to concrete	MPa	ASTM D4541	≥ 0.5